Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Harris Bipod help

Discussion in 'Shooting Gear and Storage' started by JeFF D, May 22, 2004.

Thread Status:
Not open for further replies.
  1. JeFF D

    JeFF D Member

    Joined:
    Dec 24, 2002
    Messages:
    190
    Location:
    Macomb County, Michigan
    I ordered a Harris Bipod model L1A2 from Cabelas. The problem is its canted to the left on both my VEPR K and Remington 700 ADL.

    It says in the instructions that this is adjustable by moving the brass base on there. But once I tighten down the screw it just goes right back to the same spot.
    Anybody else have this problem, am I doing anything wrong?

    Any help much appreciated,
    jeff
     
Thread Status:
Not open for further replies.

Share This Page