Help with New Mac-10

[tacweapon]

I recently acquired a Cobray Semi Mac-10 and when I got it I took it apart to clean in it but in my rush I did not take enough time to see how things went to together so now I can not figure out how to get spring and trigger assembly back in. If any one has any tips, hints, guides, photos, or videos it would help a lot

 

[saigafreake]

I had a cobray m11 the only gun ive ever owned that scared me every time i shot it. It had problems with ftf fte and i would get soft strikes on the primer. Ended up trading it for a aes10b.

 

[MGshaggy]

Tac -

I can't access it right now, but try www.cobray.com and look in their parts section. Last I was there they had exploded parts diagrams of the various models so you could easily figure out which part to order if you broke something. Aslo, for future use, I'd avoid removing the trigger assembly - its rather unecessary. Clean the bolt, barrel, firing pin (and FP channel), but leave the trigger parts in. If you feel the need to clean the lower and trigger parts blow it out with WD40 and wipe it clean. I've got an M11-9 (full-auto) and have had semi-auto M11's. I've never found the need to clean the lower any more than I outlined above; the lower is relatively open, the parts are heavier than necessary, and the tolerances are wide - its not going to malf on a little soot or dirt in there, and if its functioning properly, it shouldn't get much crap in their to begin with.