Hi Standard Duro-Matic?
- Thread starter Trung Si
- Start date
- Status
1KPerDay
Member
Which take down video? This one?
http://www.youtube.com/watch?v=QfSjVslsZxU
Don't proceed further than the field-strip process unless absolutely necessary.
The striker spring (inner spring) may be very snug on the striker. To remove the striker, remove the barrel and slide and recoil spring, then put the safety in the "fire" position, hold on to the striker, and pull the trigger. It should move forward out of its housing.
If it won't cock I'm guessing either the sear engagement surface or the corresponding notch in the striker is worn.
http://www.youtube.com/watch?v=QfSjVslsZxU
Don't proceed further than the field-strip process unless absolutely necessary.
The striker spring (inner spring) may be very snug on the striker. To remove the striker, remove the barrel and slide and recoil spring, then put the safety in the "fire" position, hold on to the striker, and pull the trigger. It should move forward out of its housing.
If it won't cock I'm guessing either the sear engagement surface or the corresponding notch in the striker is worn.
1KPerDay
Member
Strikers and springs are available from numrich/brownells/High Standard texas. For a sear you might try HS texas first. Numrich is sold out. I'd try a striker first, if it looks like yours is worn. Easy to replace.
http://www.gunpartscorp.com/catalog/Products.aspx?catid=8391
http://www.gunpartscorp.com/catalog/Products.aspx?catid=8391
- Status