With my Hornady LnL for 9MM, I typically put 1) Sizer, 2) Expander, 3) Powder Drop, 4) Bullet Feeder, 5) Bullet Seater/Taper Crimp.
I decided to get separate Seating Die and Taper Crimp Die.
Accordingly, learning the PTX Expander, I was considering this configuration: 1) Sizer, 2) Powder Drop/PTX Expander, 3) Bullet Feeder, 4) Bullet Seater and 5) Taper Crimp die.
But I find that in station 2, the Powder Drop/PTX pushes against the Primer Tube on one side and I can’t find an angle for the Powder Drop that lets me mount the Bullet Feeder in station 3.
Anyone else do this configuration successfully? Suggestions?
I decided to get separate Seating Die and Taper Crimp Die.
Accordingly, learning the PTX Expander, I was considering this configuration: 1) Sizer, 2) Powder Drop/PTX Expander, 3) Bullet Feeder, 4) Bullet Seater and 5) Taper Crimp die.
But I find that in station 2, the Powder Drop/PTX pushes against the Primer Tube on one side and I can’t find an angle for the Powder Drop that lets me mount the Bullet Feeder in station 3.
Anyone else do this configuration successfully? Suggestions?