Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

How much lube for a Kahr PM9?

Discussion in 'Handguns: Autoloaders' started by txgolfer45, Apr 19, 2003.

Thread Status:
Not open for further replies.
  1. txgolfer45

    txgolfer45 Member

    Joined:
    Dec 26, 2002
    Messages:
    679
    Location:
    Texas
    I'm used to lubricating my Glocks. How much more lubrication does the PM9 need than a Glock? Manual says "lightly lubricate" all moving parts.

    Thanks,
    Scott
     
  2. cratz2

    cratz2 Member

    Joined:
    Dec 24, 2002
    Messages:
    4,233
    Location:
    Central IN
    On my limited experience with the P9 Covert. After cleaning it completely, I wipe down all parts with a rag with a decent coating of FP-10 then wipe it back off with a dry rag which doesn't leave it completely dry. I spread a couple drops down each rail and two drops over the barrel and guide rod. Mine's worked 100% with this lubrication.
     
  3. txgolfer45

    txgolfer45 Member

    Joined:
    Dec 26, 2002
    Messages:
    679
    Location:
    Texas
    Thanks for the response!!!

    Scott
     
  4. concerned citizen

    concerned citizen Member

    Joined:
    Dec 25, 2002
    Messages:
    145
    Location:
    USA
    I do about the same as cratz2, only I use militec and red shooters choice grease on the slide rails.

    Mine has also been 100% :cool:
     
  5. Jeff OTMG

    Jeff OTMG Member

    Joined:
    Dec 25, 2002
    Messages:
    845
    Location:
    OKC, Ok. and Austin, TX part time
    I would say it depends on how tight a fit it is. Really tight means lots of lube. ;) Sorry, couldn't resist.
     
Thread Status:
Not open for further replies.

Share This Page