AuProspector
Member
I was shooting my new G32, Gen4 today at the range and was extremely pleased with it.
I had an OEM Glock barrel for a G22 with me and decided to swapped the two barrels and run some 40 S&W through it (that never happened)....
When I put the swapped barrel/slide back on the frame, there's was a problem when I went to reset the action. I noticed that the recoil spring was not flush with the end of the slide and the trigger wouldn't reset.
I tried to take the slide off but it appears the recoil spring is hung up and it won't allow me to do that.
Any ideas on what the fix is for this? I've never ran into this type of problem before. I don't want to force anything until I know what I'm doing. Also, I notice that the end of the recoil spring that is place on the barrel lug looked a little tilted (maybe 10 degrees) at the time but not being familiar with Gen 4's, wasn't to concerned.
BTW, the G32 ran great!
I had an OEM Glock barrel for a G22 with me and decided to swapped the two barrels and run some 40 S&W through it (that never happened)....
When I put the swapped barrel/slide back on the frame, there's was a problem when I went to reset the action. I noticed that the recoil spring was not flush with the end of the slide and the trigger wouldn't reset.
I tried to take the slide off but it appears the recoil spring is hung up and it won't allow me to do that.
Any ideas on what the fix is for this? I've never ran into this type of problem before. I don't want to force anything until I know what I'm doing. Also, I notice that the end of the recoil spring that is place on the barrel lug looked a little tilted (maybe 10 degrees) at the time but not being familiar with Gen 4's, wasn't to concerned.
BTW, the G32 ran great!
