Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Jewell trigger fitting?

Discussion in 'Rifle Country' started by WhiteKnight, Oct 4, 2004.

Thread Status:
Not open for further replies.
  1. WhiteKnight

    WhiteKnight Member

    Joined:
    Jun 5, 2003
    Messages:
    1,272
    Location:
    USA
    Have any of you with Jewell triggers on bolt guns had to sand/Dremel away any material from the stock in order for the Jewell to fit?

    I just installed a brand new Jewell in my Remington 700 and the barreled action will not fit into the stock. The Jewell seems to sit about an inch farther back than did the factory setup.

    See other post locate here (with pictures)
     
    Last edited: Oct 6, 2004
Thread Status:
Not open for further replies.

Share This Page