Just curious, what would be your thoughts?

[Wylie1]

I had 90 thousandths channeled out of the bottom of my Talleys. I'm liking the fit although single digit temps have me avoiding the range. Not easy to see but there are only a few thousandths between the scope and receiver's corners. I also bedded the action, polished the trigger's sear and mating face.

 

[Jim Watson]

I like it.
I assume you have adequate clearance between bolt knob, hand, and ocular bell.

 

[Wylie1]

Thanks I like it too.
The bolt shroud gets pretty close to the rear lens cap the way I have it set up.
It works nice as my right hand is headed for the trigger the thumb on the same hand can open up the rear cap, the front flips open with the other thumb. The bell does get close to the action but it does have just enough clearance.

 

[Wylie1]

My first rattle can job. More better metal's on the left.