Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Kahr polymer frame question/problem.

Discussion in 'Handguns: Autoloaders' started by glennv, Aug 16, 2006.

Thread Status:
Not open for further replies.
  1. glennv

    glennv Member

    Joined:
    Aug 13, 2006
    Messages:
    228
    I just bought a CW9 and test fired it today. I had zero malfuntions shooting 400 rounds. When I went to clean it I noticed the right front frame rail was about half as thin as the other rails. It looks as though it was cut away on the underside of the rail. The picture is poor but all you need to see is the location. Is this normal.

    PICT2150.jpg
     
  2. warmrain

    warmrain Member

    Joined:
    Jul 31, 2006
    Messages:
    109
    Location:
    Pacific Northwest USA
    The plastic frame rails are not a functional or structural part of the gun, they are just there to assist in getting the slide back onto the frame. I don't think this is an issue.
     
  3. mdao

    mdao Member

    Joined:
    May 9, 2006
    Messages:
    359
    It's normal. My CW9 looked like that.
     
  4. glennv

    glennv Member

    Joined:
    Aug 13, 2006
    Messages:
    228
    I plan to run another 3-400 rounds through it before I start carrying it, but so far the gun isa sweet shooter.
     
Thread Status:
Not open for further replies.

Share This Page