Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

kel tec / lcp bianchi holster modification

Discussion in 'Handguns: Holsters and Accessories' started by moooose102, Jun 30, 2008.

Thread Status:
Not open for further replies.
  1. moooose102

    moooose102 Member

    Joined:
    Oct 21, 2007
    Messages:
    3,024
    Location:
    West Michigan
    i bought a bianchi pocket holster for my kel tec p3at. i have been carrying it in it for a while now, and it works fine, but i like to carry a spare clip. one night, i was looking at the holster, and thought that the area behind the gun, that is desighed to keep the pistol upright and easy to draw, would make a decent place to hold a clip. so out came my exacto knife, and i cut away the stitching in the back corner. the spare clip fints in there great, with just enough room for me to still get my hands on the gun to draw. sonce i still dont know how to post photos on here, i will post a link (hopefully) in a little while on photobucket. right now, i have to seperate two screaming kids. AURGH!
     
  2. moooose102

    moooose102 Member

    Joined:
    Oct 21, 2007
    Messages:
    3,024
    Location:
    West Michigan
  3. moooose102

    moooose102 Member

    Joined:
    Oct 21, 2007
    Messages:
    3,024
    Location:
    West Michigan
    how about that, i did it! now, if i can remember how!?!???
     
  4. HB

    HB Member

    Joined:
    Dec 18, 2007
    Messages:
    1,329
    Location:
    St. Louis, MO
    Good thinking

    HB
     
Thread Status:
Not open for further replies.

Share This Page