The rear of the stock ejector on my Kimber Stainless Target II has loosened up a bit. (The ejector does not wiggle side to side; the rear of the ejector goes slightly up and down, and the gun is still 100% reliable.) I called Kimber and the service tech told me not to worry as the slide will keep it in place, but that if I wanted to, I could sent it in and they would fix it under warranty.
I was thinking that instead of sending the gun back to Kimber, I would replace the ejector with a Wilson Extended Ejector. Have any of you folks done that with the Series II with the external extractor? If so, how has it worked out?
Thanks,
Steve
I was thinking that instead of sending the gun back to Kimber, I would replace the ejector with a Wilson Extended Ejector. Have any of you folks done that with the Series II with the external extractor? If so, how has it worked out?
Thanks,
Steve