ZCORR Jay
Member
That's a slick looking shotty ya go there.
The Mesa Tactical shell holders bolts ;I heard pinches the frame ... I dont know it that would affect anything internally. I; too plan on doing the 8 shot shell holder from them but if the bolts pinching the frame affects the performance. I'll toss it in the trash...
I do have problems with turning the safety on and off but with the bigger safety switch its alot easier to reach for it with either the off hand or my thumb...
I was thinking of going with the 8shell carrier but I was told that Mesa Tactical shell carrier would make interfer with the operation of my 930SPX and I decided not to ... I'm almost at the end of the build... I havent decided whether to purchase a ETA rhino tactical rail system on this or not... I dont knowInstalled the Mesa Sure Shell on Thursday and ran 3 Gun with it on Saturday. No problems whatsoever. The Mesa uses chicago screws which will prevent pinching of the receiver if the washers are installed correctly. I only wish I went with the 8 shell holder over the 6.
So Ripp if you want a 6 shell holder, buy an 8 shell holder and I will trade you and pay the difference.
Anyone know where I can get some remington 12gauge accutip sabot slugs ???
Sabot slugs are usually for fully rifled barrels. Remington's page says as much about the Accutip sabot slugs specifically.