deadeye1122
Member
I bought a Lee case length gauge and shell holder for .223 to trim cases to a uniform length in case I start to crimp. Anyway the package and web site state Trim to length 1.730 to 1.760..
When I screw the length gauge into the cutter and it bottoms out so where is the adjustment at?
Do you file the end of the gauge to adjust length of cut?
Set up that way it cuts 1.756.
Anyone familiar with this setup?
https://leeprecision.com/gage-holder-223-rem.html
When I screw the length gauge into the cutter and it bottoms out so where is the adjustment at?
Do you file the end of the gauge to adjust length of cut?
Set up that way it cuts 1.756.
Anyone familiar with this setup?
https://leeprecision.com/gage-holder-223-rem.html