Load data for full wadcutters in .32 H&R and .327 Magnum?

[TTv2]

I'm thinking about buying 1000 Speer .314 wadcutters and I while I have data for loading them in .32 S&W Long, I don't have any for use in .32 Mag or .327 Mag. Does anybody know of or have a link to any published data for using hollow base wadcutters in the .32 magnums? I'd be a bit hesitant to use it, but does anyone have a load they've worked up?

BTW, I don't have an issue loading them in .32 S&W L. and shooting them in the magnum revolvers, it's just that I don't have as much S&W L. brass as I do H&R Mag or .327 Mag.

Not looking to push these super soft Speer bullets, under 800 fps would be more than fine as these are just cheap plinking bullets.

I have quite a few powders on hand, but would prefer to use powders I already have like Trail Boss, Titegroup, Bullseye, 700X.

I appreciate the help.

 

[cfullgraf]

Lyman Cast Bullet book, 4th edition has data for 98 grain cast solid base wadcutters for both 32 H&R Mag and 327 Fed Mag. It would be a good starting point for the HBWC bullets.

 

[Mr_Flintstone]

From Speer #12



From Load Development article https://loaddata.com/articles/PDF/LD-13 Pearce LR1.pdf