I noticed that a small percentage of a recent load of 9mm Luger boolets were "out of round" by as much as .003" and would not "chamber" in a Dillon headspace gauge. However, the rounds do chamber in my Baretta 92FS and I will attempt to shoot them, although I suspect that accuracy will be affected.
I'm guessing that the cause may have been that either I did not "bell" the cartridge sufficiently, or that I was careless when pressing the boolet into the cartridge, or some combination of both.
None of my manuals seem to address this issue. Can anyone offer any insight?
I'm guessing that the cause may have been that either I did not "bell" the cartridge sufficiently, or that I was careless when pressing the boolet into the cartridge, or some combination of both.
None of my manuals seem to address this issue. Can anyone offer any insight?