Looking for Dan Wesson Revolver Expert

[JackOfAllTradesMasterAtNone]

I have a timing issue... I think. Sometimes I get a primer hit that's more off center than I'd like to see. Most of the time, 49/50, all firing pin / primer hits are dead center. Shooting double action. One of these times things aren't going to be lined up quite right. Makes me a little nervous. :banghead:

What is the cause of this and how do I adjust it?

-Steve

 

[noklue3]

Did you try emailing them at: [email protected]

They were working on the revolvers but I am not sure anymore since CZ bought them. Couldn't hurt to ask.

Good luck,
Art

 

[JackOfAllTradesMasterAtNone]

I'm trying to stay away from the factory just yet. There's so many experienced folks here at THR, that I'd like to get edumucated from before I go that route. Besides, sending to the factory for repair isn't tops on my list of future experiences. If there's a part that's suspect, then I can probably just order and replace. That way my very versital pistol (pak) is not gone for long.

-Steve

 

[Swamp Yankee]

My first question what Model?
Second question has the gun ever been disassembled for a thorough cleaning?
If the answer to the second is no, that's where I would begin.
If you want to clean it and need help taking the revolver apart drop me a PM.
Take Care

 

[JackOfAllTradesMasterAtNone]

15-2VH and yes, it's had thorough cleanings. That's what baffles me, is the 'once in a while' I have to deal with. She's fired each time, but I'm leary of the one that's not lined up correcly.

-Steve