Lyman Chamfering Pilot

[Hondo 60]

I have a Lyman Power Trimmer & broke the blade on the chamfering bit.
Does anyone know where I can get a new one?
I posted this a week ago in the "Buy, Sell and Trade: Accessories and Parts"
But rec'd no replies.

Any help would be appreciated.

 

[dgod]

Try Lyman Tech Spt: 800-225-9626, 800-423-9704, 860-632-2020

They should be able to help you out.
Dan

 

[243winxb]

https://www.midwayusa.com/product/310638/lyman-chamfer-and-deburring-tool-for-trimmers

 

[JimKirk]

Lyman would be your best bet...

860-632-2020
800-225-9626
800-423-9704

 

[Jesse Heywood]

https://www.midwayusa.com/product/310638/lyman-chamfer-and-deburring-tool-for-trimmers

Shows as discontinued

 

[Blue68f100]

Make a replacement blade for it yourself. Looks like it's just held in place with a pin. Depending on what thickness it is a old hacksaw blade would be perfect. A little time on the grinder shaping it and it will be good to go. The hardest part would be drilling the hole for the pin. May need a solid carbide drill bit for that.

 

[Hondo 60]

I wish I could make one.
I have neither the talents nor the machinery to do so.

 

[Blue68f100]

If you can't locate a replacement sent it to me and I will see what I can do. I have a small shop with the necessary tools to do most things.

Where did it break at?

 

[Hondo 60]

the blade broke right where it sticks out of the main body.
I don't have the part that broke off, I never found it.

 

[Blue68f100]

If that's the case the picture show what it suppose to look like. If you don't find a replacement send me whats left and I will fit in a new blade. I have some old hack saw blades around if they are thick enough. I have some 440c knife steel I can use too, depending on the thickness required. I no longer have a furnace to heat treat with but can do it the old fashion way, torch. 440c see only needs to air cool to get it's hardness, then you draw it back. If too hot though you drive all of the carbon out and it want get as hard.