DustyGmt
Member
I assembled this spikes lower and began with an extended mag button release and noticed it would catch on the left (serial no. Side) so I thought since the ext mag button didnt allow the threads of the actual mag catch to go in quite as far as a standard one would, the additional distance the mag catch could cause it to catch on the reciever.
I thought I would remedy the problem by just bagging the ext release and install a standard mil spec one but I'm finding that every few mags or so the catch is catching on the reciever when I push to release the mag. Not good. Very irritating. I've done quite a few lowers and cant figure out why this is happening. There is no burs on the reciever and it seems as though it should function fine. Have any of you guys had to futz around with this problem? Pic for reference.
I thought I would remedy the problem by just bagging the ext release and install a standard mil spec one but I'm finding that every few mags or so the catch is catching on the reciever when I push to release the mag. Not good. Very irritating. I've done quite a few lowers and cant figure out why this is happening. There is no burs on the reciever and it seems as though it should function fine. Have any of you guys had to futz around with this problem? Pic for reference.
Last edited by a moderator: