Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Mauser Extractor Fitting?

Discussion in 'Rifle Country' started by jonnyc, Aug 9, 2007.

Thread Status:
Not open for further replies.
  1. jonnyc

    jonnyc Member

    Joined:
    Dec 5, 2004
    Messages:
    2,341
    Location:
    SE Pennsylvania
    I put a new extractor on my Israeli K98. Works great without rounds. Picks up and extract rounds great. Chambering and locking is hard on about half the rounds tried.
    I am assuming I need to reduce the claw a bit but that the front foot, near the bolt head is fine.
    Does that sound correct, and is there a special way to do this job?
     
  2. jonnyc

    jonnyc Member

    Joined:
    Dec 5, 2004
    Messages:
    2,341
    Location:
    SE Pennsylvania
    No words of wisdom???
     
  3. GunTech

    GunTech Member

    Joined:
    Mar 16, 2007
    Messages:
    3,878
    Location:
    Helena MT
    Is this a military extractor? Does it have the bevel on the front? Are you feeding rounds from the magazine, or directly dropped into the chamber?
     
  4. jonnyc

    jonnyc Member

    Joined:
    Dec 5, 2004
    Messages:
    2,341
    Location:
    SE Pennsylvania
    New extractor, probably mil-surp.
    Yes, front is beveled.
    From the mag.
     
Thread Status:
Not open for further replies.

Share This Page