Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Mauser Sight Hood question

Discussion in 'Rifle Country' started by Thompson9494, Mar 9, 2013.

Thread Status:
Not open for further replies.
  1. Thompson9494

    Thompson9494 Member

    Joined:
    Feb 28, 2013
    Messages:
    118
    Location:
    Texas
    I've finally managed to find a little more ammo for my new M24/47 Mauser, so I'll probably be taking it out to the range here pretty soon to sight it in. This leads me to a slight problem. The sight has been drifted to the right slightly, I don't know if this is going to work out or not, if I go out and find the rifle shoots straight without any fuss then I'll be fine, but if I go out there and find out it is shooting to the right or whatever, I'm gonna have to adjust the sight which will be difficult because of the hooded sight. Is there a tool I need to remove the hood, or can I just do it with some out of the garage??


    Thanks!!
     
  2. rcmodel

    rcmodel Member in memoriam

    Joined:
    Sep 17, 2007
    Messages:
    59,082
    Location:
    Eastern KS
    Stick a pair of needle nose pliers in the sight hood and pull the handles apart.

    It will spring the hood apart far enough to slide it off.

    rc
     
  3. musicman10_1

    musicman10_1 Member

    Joined:
    Mar 27, 2012
    Messages:
    240
    Location:
    Chandler, Arizona
    Snap ring pliers are the tool that you need.
     
Thread Status:
Not open for further replies.

Share This Page