Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Minor dings on Loadmaster

Discussion in 'Handloading and Reloading' started by Rustynuts, Jan 7, 2008.

Thread Status:
Not open for further replies.
  1. Rustynuts

    Rustynuts Member

    Joined:
    Mar 29, 2007
    Messages:
    730
    Just took delivery and there are a couple of small spots where the finish is chipped off right out of the box. What is this press made of, will it rust if not coated? Wouldn't even pay attention to them normally, but one is smack in the middle staring at me when I'm in front of the press! Any color match to auto paint, or does Lee sell paint?
     
  2. Idano

    Idano Member

    Joined:
    Oct 2, 2006
    Messages:
    933
    Rustynuts;

    I don't have my Loadmaster any longer but if I am not mistaken they're cast aluminum so rust won't be a problem. Sorry, but I can't help you with the paint, do a search on LEE paint on this forum because I think I recall something about matching the paint in an old post.
     
  3. FieroCDSP

    FieroCDSP Member

    Joined:
    Nov 12, 2006
    Messages:
    2,146
    Location:
    Wooster, Ohio
    It was the "Lee Pheonix Press" thread. A guy did the paint on one that had been in a fire with red Krylon. Either the brush on or spray type would work, so long as it's not the latex based. If I recall correctly, Krylon comes in either Banner Red or Cherry Red. I believe Banner Red is the lighter, and closer to Lee, of the two,but I'm not sure.
     
Thread Status:
Not open for further replies.

Share This Page