Moonclips for Security Six

[Aged In Oak]

Does anyone know of a gunsmith who will do machining on a Security Six for moonclips? I checked around a bit, and all the Ruger smiths I found list GP-100, SP-101, Redhawk, etc., but no S6. I have a couple smiths in mind that I'll contact directly to ask, but I thought I'd post the question here too. Also, anyone had this conversion done on an older revolver like an S6?

 

[dbarale]

Pinnacle lists the Security Six on their web site.
http://www.pinnacle-guns.com/revolver.asp

Scroll down to the bottom of the page...

 

[Seiko]

http://www.tkcustom.com/
he has a list of gunsmiths that do the moon clip conversions approved by him.

Pinnacle is a good one. Very reasonable prices.

 

[Brian Williams]

Just send the cylinder, it saves overnight costs.
I have used Mark at Pinnacle for a moonclip conversion for my S&W 65.

 

[jameslovesjammie]

I contacted Mark recently about cutting my 686 for clips and he said that if he receives it before the 27th it will go in his next batch when they get set up. They're going to start cutting on the 27th, so he would obviously need it before that. Sounds like he only cuts about once a month.

Mark did a GP100 for my uncle. The job was top notch and finish was excellent.