You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
moved
- Thread starter grimjaw
- Start date
- Status
-
Not open for further replies.
jpwilly
Member
You should post this in the gunsmithing and repairs area.
IMO the pins should fit snugly enough to require a few taps from a small brass hammer and punch to put it in place. This will keep it from working loose
IMO the pins should fit snugly enough to require a few taps from a small brass hammer and punch to put it in place. This will keep it from working loose
- Status
-
Not open for further replies.