My new 10/22 with some changes :)

Status
Not open for further replies.
B

bsctov

Member
Joined
Mar 5, 2009
Messages
336
After losing my last 10/22 to some very unfortunate circumstances, I decided it was time for another one.


So I picked up the "Stainless" 10/22 from a local Dick's with my new UPIN and it went through right away. Ordered some parts offline and ended up with this.

The timestamps on the photo are wrong because the camera battery died, and I just did not feel like messing with it atm.

(Still waiting for my leatherwood red dot tomorrow)

But here she is:

000_0002.jpg
000_0004-1.jpg

Wearing a TAPCO Intrafuse stock, TAPCO Vertical Grip, NCSTAR tac light on the right, and a ncstar laser on the right, and a tactical inc polymer bolt buffer, and tactical inc flash hider to top it all off.
 
Last edited:
So far, only fired 1 single aquila super colibri through it..


Waiting for my red dot to arrive, should be today hopefully.


I have a tactical inc mag, but its a polymer one, and i snapped off one of the screws like a moron, plus the steel lips stuff is always sold out dry. Doesn't look like i'll be getting one for awhile.


*EDIT- the steel lips were listed as in stock a few minutes ago, so i went ahead and ordered one. Hopefully this one fits in the gun and doesnt cause the bullets to be sheered by the movement of the bolt.
 
Last edited:
have one question, I just got my red dot scope, and noticed the front red lens is slanted to the right, is that normal?
 
As long as you like it I guess that is what is important. As for the dot I would think the lenses should be square but as with any low cost optic sometimes you get what you pay for. You could probably return it for exchange but if it works right I think I would just go ahead and use it.
 
Status
Not open for further replies.
Back
Top