Neck Turning Suggestions

[capreppy]

I am about to build a 260 Rem bolt action and I want to spend some money for accurate loads.

I'm looking to get the Redding Competition Die set for 260 Rem.

I want to neck turn the brass (RP headstamp and I'll cull through them by weight once I get the brass). Once neck turned, I'll decide which bushing is necessary for the neck sizing die.

So my question is around neck turning. What are some better (but still cost effective) solutions out there.

I have an RCBS trimmer, but have seen the reviews for the neck turning accessory as being pretty poor so not going that route.

Thoughts?

 

[flashhole]

The K&M system works really well. If you go this route make sure you get the Expandiron.

 

[Walkalong]

Another K&M vote, but the Sinclair neck turner is very nice as well. Many folks would buy multiple tools if they needed to turn to more that one diameter.

 

[capreppy]

Definitely looking at the K&M. Lots of info on AccurateShooter and price is very reasonable.

I'm not looking to do high volume as I'll probably pick up 500 pieces of brass and will only need to turn them once (maybe a second time after fire forming). I doubt I'll do any neck turning on my 223 or 308.