capreppy
Member
I am about to build a 260 Rem bolt action and I want to spend some money for accurate loads.
I'm looking to get the Redding Competition Die set for 260 Rem.
I want to neck turn the brass (RP headstamp and I'll cull through them by weight once I get the brass). Once neck turned, I'll decide which bushing is necessary for the neck sizing die.
So my question is around neck turning. What are some better (but still cost effective) solutions out there.
I have an RCBS trimmer, but have seen the reviews for the neck turning accessory as being pretty poor so not going that route.
Thoughts?
I'm looking to get the Redding Competition Die set for 260 Rem.
I want to neck turn the brass (RP headstamp and I'll cull through them by weight once I get the brass). Once neck turned, I'll decide which bushing is necessary for the neck sizing die.
So my question is around neck turning. What are some better (but still cost effective) solutions out there.
I have an RCBS trimmer, but have seen the reviews for the neck turning accessory as being pretty poor so not going that route.
Thoughts?