Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New Argy HP

Discussion in 'Handguns: Autoloaders' started by jonnyc, Dec 26, 2006.

Thread Status:
Not open for further replies.
  1. jonnyc

    jonnyc Member

    Joined:
    Dec 5, 2004
    Messages:
    2,341
    Location:
    SE Pennsylvania
    I just got a new Argy HP, would appreciate any info on year/age, contract /user, etc.

    Black enamel finish seems original.
    Small safety, spur hammer, front lightening cuts.
    Left side: F.N. BROWNING ARGENTINA FMAP HI-POWER
    The F.N. BROWNING is sharp, deep, and even but the ARGENTINA etc. is very light and uneven.
    Right side: Matching proofs on barrel and trig. guard, T(with star on top) at rear of slide, P on frame just below safety shaft stub.
    Matching serial #289XXX on frame/slide/barrel, but not aligned.
    Importer "C.M.O." on grip base behind mag opening.

    Thanks in advance.
     
    Last edited: Dec 26, 2006
  2. jonnyc

    jonnyc Member

    Joined:
    Dec 5, 2004
    Messages:
    2,341
    Location:
    SE Pennsylvania
    Shot it today, very nice. Shoots to POA. Only glitch was last round in the mag it came with didn't feed right. The other 8 I brought were fine. I'll give that one a few more goes before any drastic action. Just took the mag disconnect out. Will test again tomorrow...if lucky!
    I'd still like to hear any thoughts or info.
     
Thread Status:
Not open for further replies.

Share This Page