1911Competitor
Member
- Joined
- May 11, 2017
- Messages
- 3
Hi All,
hope to learn a lot from you guys.
I am about to dive into my first 1911 trigger job and need some advice on tools and techniques:
1) Sear I will purchase the Warner TR jig and follow instructions
2) Trigger and trigger channel - I bought a trigger channel stone from brownells. Also bought some eze lap diamond hone and stones
3) Sandpaper to slightly take the edge off disconnector and firing pin safety, also to round the rear of the trigger bar where it makes contact with the disconnector
4) This is where I need your help....what jig/tools do I need to work on the hammer?
And, do you recommend I do anything else to smooth and improve the trigger pull? I searched the thread and saw a few homestyle trigger jobs that involve bending the sear spring, but frankly I am not comfortable with something that can't be measured with repeat results.
Thanks in advance everyone
hope to learn a lot from you guys.
I am about to dive into my first 1911 trigger job and need some advice on tools and techniques:
1) Sear I will purchase the Warner TR jig and follow instructions
2) Trigger and trigger channel - I bought a trigger channel stone from brownells. Also bought some eze lap diamond hone and stones
3) Sandpaper to slightly take the edge off disconnector and firing pin safety, also to round the rear of the trigger bar where it makes contact with the disconnector
4) This is where I need your help....what jig/tools do I need to work on the hammer?
And, do you recommend I do anything else to smooth and improve the trigger pull? I searched the thread and saw a few homestyle trigger jobs that involve bending the sear spring, but frankly I am not comfortable with something that can't be measured with repeat results.
Thanks in advance everyone