Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New M1 Garand quiz

Discussion in 'Rifle Country' started by eclancy, May 11, 2003.

Thread Status:
Not open for further replies.
  1. eclancy

    eclancy Member

    Joined:
    Dec 26, 2002
    Messages:
    1,114
    Location:
    N. Catasauqua, Pa
    Hi all,
    Here's a hard one. The striker indent during testing on the M1 Garand was tested using "a copper compression cylinders" on the M1. What was the required depth of the striker indent to past the test ?
    Have fun with this one
    Good luck
    Thanks again
    Clancy
     
  2. eclancy

    eclancy Member

    Joined:
    Dec 26, 2002
    Messages:
    1,114
    Location:
    N. Catasauqua, Pa
    Hi all,
    The answer about the striker indent is inch--0.016.
    Thanks again
    Let me know if you want another
    Thanks again
    Clancy
     
Thread Status:
Not open for further replies.

Share This Page