Hello everyone,
New to revolvers but not hand guns.
Anyway I purchased a brand new 637 I havent taken to the range yet. I noticed the next day the screw holding in the thumb latch that open the cylinder was loose. So no biggie I took the right size screw driver and made it snug but not too tight. I called CS and they told me that sometimes this happens and just to tighten it.
My question is ... should i use clear nail polish or blue loctite or just leave it be?
I dont wanna dwell on this if I can as I've always wanted a smith revolver.
Also, There is a very small amount of play on the thumb latch but CS says that's perfectly normal. Opinions? A friend of mine says that's perfectly normal as well.
Any help would be appreciated even if it's a new revolver owner being worried over nothing. Thanks
New to revolvers but not hand guns.
Anyway I purchased a brand new 637 I havent taken to the range yet. I noticed the next day the screw holding in the thumb latch that open the cylinder was loose. So no biggie I took the right size screw driver and made it snug but not too tight. I called CS and they told me that sometimes this happens and just to tighten it.
My question is ... should i use clear nail polish or blue loctite or just leave it be?
I dont wanna dwell on this if I can as I've always wanted a smith revolver.
Also, There is a very small amount of play on the thumb latch but CS says that's perfectly normal. Opinions? A friend of mine says that's perfectly normal as well.
Any help would be appreciated even if it's a new revolver owner being worried over nothing. Thanks