Norinco MAK 90 Help

[peck1234]

As you can see in the picture below This model has the thumbhole stock

I lost the original hardware to mount the stock I was wondering if any of you know what hardware I need and or where I can order it? If I have to buy the same stock in order to get the hardware that's no problem.

 

[Havok7416]

I'll have to look but I ordered replacement parts for mine years ago. I have since converted the gun over to a "regular" AK variant, but I'm sure the parts are still out there

 

[fireman 9731]

From: http://www.ironwooddesigns.com/IWDhardware.html

Chinese MAK 90 thumbhole stock version 3 3/4” ( 95mm)
Most common Eastern European version 4” (100mm)
Hungarian SA85/AMD version 4 3/8” (111mm)
( lengths are measured below the screw head)

The wood screw that goes from the top of the back of the receiver down into the stock should be the same as any other AK stock screw.

So basically, you need a grip screw and stock screw, the grip screw for the MAK is just a little shorter than standard length.

 

[Acera]

I'll have to look but I ordered replacement parts for mine years ago. I have since converted the gun over to a "regular" AK variant, but I'm sure the parts are still out there

Did you follow all the rules as prescribed by 18 USC 922r?





http://www.gunwiki.net/Gunwiki/BuildAkVerifyCompliance

http://www.tapco.com/section922r/


.

 

[Havok7416]

Did you follow all the rules as prescribed by 18 USC 922r?





http://www.gunwiki.net/Gunwiki/BuildAkVerifyCompliance

http://www.tapco.com/section922r/


.

Why yes I did. Handguards and stock were ordered from Ironwood Designs and the remaining parts, magazines included were all US-sourced.

 

[barnbwt]

Yes indeed, it is a good thing that you made sure that your rifle was 100% compliant or you would have to deal with the myriad of hand-wringers out there.

Come now, just think of all the American jobs that law has created, LOL

 

[Coyote3855]

Let's hope that concerns about this 922r BS will change in the next few months.