Got my press today, I have loads of brass that I have tumbled in walnut shells just to get 'clean'. I set that aside.
I'm wondering the steps others go through next. I was thinking deprime, then run in corn media to get the pockets cleaned out, then lube and size and prime at the same time. This is .223 btw.
But I notice with the setup you could tumble, then lube, and size and de-prime and re-prime all in one stroke.
Do others de-prime then clean pockets or just de then re all in one?
I'm wondering the steps others go through next. I was thinking deprime, then run in corn media to get the pockets cleaned out, then lube and size and prime at the same time. This is .223 btw.
But I notice with the setup you could tumble, then lube, and size and de-prime and re-prime all in one stroke.
Do others de-prime then clean pockets or just de then re all in one?