Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

P250 Recoil Spring

Discussion in 'Handguns: Autoloaders' started by Hunterdad, Oct 23, 2011.

Thread Status:
Not open for further replies.
  1. Hunterdad

    Hunterdad Member

    Joined:
    Dec 23, 2009
    Messages:
    1,873
    Location:
    Syracuse, NY
    Traded in a Dan Wesson .357 for a full size P250 in .45. I originally wanted a 9mm but was reminded by my wife that I have 1000rds of handloaded .45 that I got from a buddy for my 1911. Anyways, got to the range to put some rounds through it and it won't eject the handloads. It runs the wwb loads just fine though. I had the same problem with my 1911 not cycling the handloads and had to swap out the factory 16# spring to a 14# spring. Can I get a lighter spring for my Sig and of so, what should I go with?

    Thanks
    Adam
     
  2. WinThePennant

    WinThePennant Member

    Joined:
    Jul 8, 2011
    Messages:
    1,136
    Location:
    Earth
    Hmmmm.... It ejects factory ammo, but not your handloads?
     
  3. Hunterdad

    Hunterdad Member

    Joined:
    Dec 23, 2009
    Messages:
    1,873
    Location:
    Syracuse, NY
    Yes, that's correct. I know the handloads are loaded a little light.
     
Thread Status:
Not open for further replies.

Share This Page