Quantcast
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Peltor Tactical 6-s - anyone know where the batteries go?

Discussion in 'General Gun Discussions' started by wooderson, Dec 22, 2006.

Thread Status:
Not open for further replies.
  1. wooderson

    wooderson member

    Joined:
    Nov 29, 2006
    Messages:
    1,085
    Location:
    Tejas
    I was given a pair of Peltor Tactical 6-s 'muffs by my parents today, but sans instructions (and no dice on the Peltor site).

    I can't seem to figure out what I pull off to load the batteries. Help, please?
     
  2. TeachMe

    TeachMe Member

    Joined:
    Aug 25, 2005
    Messages:
    91
    The padding pulls off, but can be tricky to remove (at least on mine). I usually look for a small indentation on the outside of the padding, between it and the plastic. If you can use something small enough to fit in there to get a little leverage, you can lift the padding up easily. Then the foam piece is free to come out and you'll see where the batteries go.
     
  3. MisterPX

    MisterPX Member

    Joined:
    Jun 3, 2006
    Messages:
    759
    Location:
    Amerika's Doyleland
    Right by the nub that holds the headset on, is an indentation in the ear foam cover. Pop it off, and presto. May be easier if you pop off the headset.
     
  4. wooderson

    wooderson member

    Joined:
    Nov 29, 2006
    Messages:
    1,085
    Location:
    Tejas
    Thanks, that did it. It looked like the batteries had to go underneath but I wasn't keen on starting to pull the covers off without being sure.
     
Thread Status:
Not open for further replies.

Share This Page