Please help me identify.....

Status
Not open for further replies.
trixter

trixter

Member
Joined
Mar 1, 2011
Messages
116
Location
Where E. Pine St. crosses I-5, OREGON
I came into possession of an old RCBS single stage press. This thing is built like a tank. The main ram is about 1" or a little more. Then the last part on top of the ram is about 3/4" for about the last 3 inches. It has a spring loaded shell holder opening to use modern shell holders. The handle is loose on the bottom to enable it to rotate as you move it up and down. Green handle grip of course. the press itself bolts to a mount on the rear with two bolts and the foot/stand has two slots in it. It has RCBS emboldened on the front and rear of the 'O', and a very big 2 on the lower part of the ram tube. If no one can figure it out I will try to get a couple of photos if i can find that darn camera.
 
A pic is worth a thousand words !!

But ya lost me at the different sizes of rams & loose handle , all the rcbs presses I`ve seen the handle was tite & the ram straight except maybe a bit at the top angled a bit to match the shellholder dia.

The 2 slots to bolt it down & the no.2 cast into it has me thinking "Reloader Special 2" but the ram ????
 
The toggles go all the way to the top ?????

& yeah it`s a KAT DADDY when it comes to presses !!!

Make sure ya lube your rifle cases enuff to get out of the die because it has enuff ummpphh to push a dry case in a die !!!!!
 
Status
Not open for further replies.
Back
Top