I've been reading up on reloading, and have ended up comparing two powders against each other.
I want to reload 9mm ammo.
The powders I am comparing are ADI's AP-50N and AP-70N
50 is faster burning than 70.
The ADI website says that the 70N goes with 115 grain bullets, and for 120 grains use 50N or 100.
Anyways, what would the effect of using a lighter projectile with the faster burning powder?
Would it be less snappy than the same powder with a heavier bullet?
Would it be better on the cases to use the slower powder? I plan on loading cost-effectively, not for high power.
Also, what is everyone's opinion of the ADI powder? It seems I don't have much choice on what brand I can use over here.
I want to reload 9mm ammo.
The powders I am comparing are ADI's AP-50N and AP-70N
50 is faster burning than 70.
The ADI website says that the 70N goes with 115 grain bullets, and for 120 grains use 50N or 100.
Anyways, what would the effect of using a lighter projectile with the faster burning powder?
Would it be less snappy than the same powder with a heavier bullet?
Would it be better on the cases to use the slower powder? I plan on loading cost-effectively, not for high power.
Also, what is everyone's opinion of the ADI powder? It seems I don't have much choice on what brand I can use over here.