Automac
Member
Is anybody else out there still trying to twist one of these things by hand? It gets pretty old after a while to me, but it works. I looked on Midway's list for power units but couldnt find somthing simple with power.
I found a pretty good way, that I'm sure isn't new. I'm sure some of you guys are doing this already, or have better ways. But if youve been doing it the hard way, try this...
Get one, if you dont have an adjustable speed Dremel (you need it). The 1/2" rubber sandpaper holder fits inside the tool pretty good, and works even tho its a bit loose (-.015?)(snug it up as much as you easily can with the screw 1st). On the lowest speed possible, holding upright, the thing works great with the right touch. You can touch it too, if it isnt burred. Press it down carefully with your finger when its running to position it. Mine doesnt bite me. Then put the case on evenly with just enough pressure to keep it from chattering, for less than a second. It's like a dream compared to twisting them out. With not enough pressure to stop it, you can almost count just the few revolutions needed. Look, its perfect for the inside chamfer, and pretty fast too, no?!
I found a pretty good way, that I'm sure isn't new. I'm sure some of you guys are doing this already, or have better ways. But if youve been doing it the hard way, try this...
Get one, if you dont have an adjustable speed Dremel (you need it). The 1/2" rubber sandpaper holder fits inside the tool pretty good, and works even tho its a bit loose (-.015?)(snug it up as much as you easily can with the screw 1st). On the lowest speed possible, holding upright, the thing works great with the right touch. You can touch it too, if it isnt burred. Press it down carefully with your finger when its running to position it. Mine doesnt bite me. Then put the case on evenly with just enough pressure to keep it from chattering, for less than a second. It's like a dream compared to twisting them out. With not enough pressure to stop it, you can almost count just the few revolutions needed. Look, its perfect for the inside chamfer, and pretty fast too, no?!