problem solved, thanks everyone
P Pronghorn19 Member Joined Jan 3, 2012 Messages 45 Jun 5, 2014 #1 problem solved, thanks everyone Last edited: Jun 5, 2014
R rcmodel Member in memoriam Joined Sep 17, 2007 Messages 59,074 Location Eastern KS Jun 5, 2014 #2 Push the slide back on the frame until it is even on the back. Then without letting it slip back where it is. Snap the trigger, pull down the slide release, and slip the slide off. rc
Push the slide back on the frame until it is even on the back. Then without letting it slip back where it is. Snap the trigger, pull down the slide release, and slip the slide off. rc
R rcmodel Member in memoriam Joined Sep 17, 2007 Messages 59,074 Location Eastern KS Jun 5, 2014 #3 Not nice, or good form on THR to edit out a post question after it has been answered! Someone else might need the same answer tomorrow! Don't do that! MmmmmKaaaaa? rc
Not nice, or good form on THR to edit out a post question after it has been answered! Someone else might need the same answer tomorrow! Don't do that! MmmmmKaaaaa? rc
bikerdoc Moderator In Memoriam Joined Jan 8, 2008 Messages 25,191 Location Southern Virginia Jun 5, 2014 #4 RC is correct so Im locking this.