Auburn1992
Member
Ok, in my other thread I mentioned I gotta new Jewell Trigger for my XR-100.
It installed fine, but I needed to sand some things down. It looks as if the safety is not going to engage (mobe back all the way) unless I do !A LOT! of sanding around that area. The safety design is way different from the original trigger, and the bolt release is a little wider.
What should I do about the safety. I don't really want to spend 5 hours sanding it down to get it to work.
By chance, will this effect accuracy by anding the stock down near the trigger?
Thanks,
AU
It installed fine, but I needed to sand some things down. It looks as if the safety is not going to engage (mobe back all the way) unless I do !A LOT! of sanding around that area. The safety design is way different from the original trigger, and the bolt release is a little wider.
What should I do about the safety. I don't really want to spend 5 hours sanding it down to get it to work.
By chance, will this effect accuracy by anding the stock down near the trigger?
Thanks,
AU
