rperyam
Member
I found a box of 5000 CCI large pistol primers while looking for something else in my garage. I normally use Winchester primers while reloading on my Dillon Square Deal. I started with some Winchester brass but could not seat the primers fully in most attempts. I then tried some Speer, Federal and finally some S&B brass. 8 out of 10 were not fully seated.
I don't remember these problems using CCI primers on 9 mm. Is this typical? Any suggestions others than selling or trading these primers? Thanks.
I don't remember these problems using CCI primers on 9 mm. Is this typical? Any suggestions others than selling or trading these primers? Thanks.