snook-slayer
Member
I’m moving up in the reloading world, after handing down the single stage press my father gave me, I bought my first progressive. I’m gearing up and a question came to mind, When loading necked brass …. Say 223, using a full length sizer decaper in a progressive setup, when should you trim and chamfer? Before you put the casings in the progressive or do it in two stages, i.e. run them through first with just the decaper / sizer die in place and then trim and chamfer and load them back into the press to complete the process.
Or is there some thing else I’m not thinking of?
Thanks in advance.
Or is there some thing else I’m not thinking of?
Thanks in advance.