PSA freedom Lower

[kBob]

Its the weekend so why ask PSA when I can ask You guys......

anyone know the size allen wrench needed to tighten the pistol grip screw on the PSA Freedom Lower?

I started mine with a #2 pencil eraser to get an idea of what the final assembly will be like and to retaine the selector and spring/detent for the same while doing other stuff and now can't get it loose the same way. I find I have nothing that can reach the darn thing in the pistol grip and must buy something to finish the job......grumble mumble mumble......my lack of patience.

BTW as ten days of not posting is a record for me let me say I am not dead, incapacitated, or incarceratied just a Bell South customer that is being well and truly serviced. DSL went out Friday was a week ago and have been promised almost daily that the problem would be resolved by 6:22 PM most days. I am starting to think a dish and some other service might be the only recourse.

Also Matthew did little damage in the Gainesville area and points east saw mostly flood damage rather than wind.

-kBob

 

[kcofohio]

If it is 1/4" screw that I remember. It will be a 3/16" allen wrench.

 

[badkarmamib]

I never could get an allen wrench to fit well in any of mine, so I use a T30 Torx bit.

 

[Sistema1927]

You might just have the right size flat head screw driver that will both reach and fit.

 

[Mgaines]

Yep I us T-30 Torx also.

 

[kBob]

SO I bought a "25 piece T-Handle Set" from the junk tables at Tractor Supply (marked down from $9.99 to $6.99) as it said on the back it included a T30. It did , but a short one. Fortunately one of the long allen wrench bits marked as 3/16 inch fit and worked well.

No more grip wobble or fear of buggering the selector spring and detent and another cheap crappy tool kit to clutter up the shop!

Yay!

Thanks for the suggestions guys.

-kBob