Rottweiler
Member
I was thinking about this while sizing a coffee can of .38's the other evening...
Is there any reason why a sizer can't be made to push a bullet all the way through a die and drop free on the other end instead of down into the die and back up out of the die? Seems to me this would make the sizing process MUCH faster if you only had to handle the bullet to set it in the die instead of in and then back out.
Is there any reason why a sizer can't be made to push a bullet all the way through a die and drop free on the other end instead of down into the die and back up out of the die? Seems to me this would make the sizing process MUCH faster if you only had to handle the bullet to set it in the die instead of in and then back out.