Ok guys , i'm not a rifle loader(till now). But have extensive pistol experience. I have 8k hornady 75gr hpbt match to load for dcm matches. Load is established. 24.2gr varget. I have the 8k brass run through my 1050 press to prep for loading. Each case was full length sized, primer pocket swaged, trimmed to length, re tumbled to remove lube and small cuttings.
When i attempted to load the first batch of ammo i found the cases scraping the bullets removing jacket material i could see. I have been told that i need to ream, bevel the inside of the case neck with a vld trimmer/ reamer to allow for the different angle of the bullet base. I want to mount the vld reamer and ream each case to the exact amount. Which trimmer base unit will allow me to set up a stop so that each case is reamer the same? Tia jim p
When i attempted to load the first batch of ammo i found the cases scraping the bullets removing jacket material i could see. I have been told that i need to ream, bevel the inside of the case neck with a vld trimmer/ reamer to allow for the different angle of the bullet base. I want to mount the vld reamer and ream each case to the exact amount. Which trimmer base unit will allow me to set up a stop so that each case is reamer the same? Tia jim p