Uranophobic Unicorn
Member
- Joined
- Jul 31, 2019
- Messages
- 13
Recently picked up Quickload; it's nothing short of magic, it seems. One thing is kinda bothering me, there isn't much of selection of projectiles. I suppose that's not much of an issue because you can enter your own projectile parameters pretty easily. But you can't really adjust how "hard" your bullet is.
Clearly shot start pressure is what I'm looking for here. They give a few "rules of thumb" in their little tool tip, but they don't give any advice for cast rifle projectiles. Default is 3626psi, and molycoated projectiles are about 2/3's as slippery. Molycoating is a bit before my time, but perhaps it's comparable to powder coating? Maybe?
With a tool this popular, surely someone's figured out a good rule of thumb here. Bistow this wisdom on me, o internet.
Clearly shot start pressure is what I'm looking for here. They give a few "rules of thumb" in their little tool tip, but they don't give any advice for cast rifle projectiles. Default is 3626psi, and molycoated projectiles are about 2/3's as slippery. Molycoating is a bit before my time, but perhaps it's comparable to powder coating? Maybe?
With a tool this popular, surely someone's figured out a good rule of thumb here. Bistow this wisdom on me, o internet.