Has anyone here mounted the new RCBS Bullet feeder on a Hornady LNL with case feeder?
I have figured out three ways not to and still do not have it in the happy place. Five holes: Size/deprime, powder/case flare, bullet feeder, seater, taper crimp. This requires placing the feeder on the right side. There does not seem to be room or reach for the bullet drop tubes from behind the handle priming position. Would like to use their pole mount, but could fabricate a new one.
Does anyone know of a source for the springs they used as a drop tube?
PS: Ordered feeder on April 21st, arrived July 9th from MidwayUSA with one broken part that I built and replaced already.
I have figured out three ways not to and still do not have it in the happy place. Five holes: Size/deprime, powder/case flare, bullet feeder, seater, taper crimp. This requires placing the feeder on the right side. There does not seem to be room or reach for the bullet drop tubes from behind the handle priming position. Would like to use their pole mount, but could fabricate a new one.
Does anyone know of a source for the springs they used as a drop tube?
PS: Ordered feeder on April 21st, arrived July 9th from MidwayUSA with one broken part that I built and replaced already.