Alllen Bundy
Member
I finally received a Reculse TS Front Pocket Holster for my Sig P365X. It took 1 day shy of 5 weeks before it was shipped. The lead time was estimated at 2-3 weeks. I can deal with hand made products taking longer than expect to manufacture. In fact, I tend to expect it.
But I didn't get what was pictured online and there are performance issues. I am NOT a happy camper. Let's look at what was pictured on the website vs what I actually received.
This is what was pictured on the website for a Sig P365:
Below is what I actually received. Note that he did make the holster wider to accommodate the taller grip module of my P365X. The flap on the upper left section is not as wide as pictured. But that is not the main issue.
Note that the portion of the holster that rests against your body comes up closer to the handgrip than what is pictured in the ad photo. This is making it difficult for the holster to spread wide enough, making it difficult to grasp the handgrip. Also, during the draw, my middle finger catches on this leather portion that is higher than it is supposed to be. This IS a problem!
It appears that I will need to lower the position of the horizontal stitching and remove the leather above the horizontal stitching.
Does anyone have any other practical suggestions?
Functionally, the DeSantis Nemesis pocket holster (Below) works much better than the Recluse, except that it prints badly.
.
But I didn't get what was pictured online and there are performance issues. I am NOT a happy camper. Let's look at what was pictured on the website vs what I actually received.
This is what was pictured on the website for a Sig P365:
Below is what I actually received. Note that he did make the holster wider to accommodate the taller grip module of my P365X. The flap on the upper left section is not as wide as pictured. But that is not the main issue.
Note that the portion of the holster that rests against your body comes up closer to the handgrip than what is pictured in the ad photo. This is making it difficult for the holster to spread wide enough, making it difficult to grasp the handgrip. Also, during the draw, my middle finger catches on this leather portion that is higher than it is supposed to be. This IS a problem!
It appears that I will need to lower the position of the horizontal stitching and remove the leather above the horizontal stitching.
Does anyone have any other practical suggestions?
Functionally, the DeSantis Nemesis pocket holster (Below) works much better than the Recluse, except that it prints badly.
.