Title says it all...
Following the instructions in the Sinclair catalog...
" .002in smaller than the average neck diameter of loaded cartridges.
My .223 reloads average 0.252 inches neck diameter.
Therefore, 0.250in bushings are the size.
Anyone disagree?
Suggestions?
I'm replacing the Dillon sizing die on my 550 -
Decapping pin with expander ball pulls apart at the stem connection.
I believe the thread is shot.
I love the Redding Competition die - consistent and exact!
Should have bought the set.....
TIA
docgary.
Following the instructions in the Sinclair catalog...
" .002in smaller than the average neck diameter of loaded cartridges.
My .223 reloads average 0.252 inches neck diameter.
Therefore, 0.250in bushings are the size.
Anyone disagree?
Suggestions?
I'm replacing the Dillon sizing die on my 550 -
Decapping pin with expander ball pulls apart at the stem connection.
I believe the thread is shot.
I love the Redding Competition die - consistent and exact!
Should have bought the set.....
TIA
docgary.