Bowdenknxvll
Member
- Joined
- Oct 17, 2009
- Messages
- 7
I have recently bought a Mossberg rimfire and tried refinishing the stock. The process I used is as follows:
1.remove finish with Formbys stripper
2. sand down to 600 grit
3.wet sand with tung oil
4. apply at least 10 coats of tung oil and then wax with Johnsons wax.
It looks pretty good, but I am not happy with it. I was thinking about trying truoil but I was wondering if I had to restrip it. I didn't fill the pores well enough and it seams like someone put a stain on before that wasn't removed with the stripper. Can i just sand with 320 or so and start all over putting more time into filling the pores and finishing with truoil or do I have to restrip sand stain etc?
1.remove finish with Formbys stripper
2. sand down to 600 grit
3.wet sand with tung oil
4. apply at least 10 coats of tung oil and then wax with Johnsons wax.
It looks pretty good, but I am not happy with it. I was thinking about trying truoil but I was wondering if I had to restrip it. I didn't fill the pores well enough and it seams like someone put a stain on before that wasn't removed with the stripper. Can i just sand with 320 or so and start all over putting more time into filling the pores and finishing with truoil or do I have to restrip sand stain etc?