Ok folks, here's the dealio:
Been reloading 9mm for a few months now for my CZ75bd. Loaded 500 rounds of Laser-Cast 124grains with 4.2grains w231. COL was 1.100. I had no problems with these and they functioned fine. Now I'm using 115 grain Meisters with 4.3grains of w231. Same COL. Now I'm having problems with the slide not going all the way back when loading a new mag or when the slide recoils after a shot. The slide locks up and it's hard to get the round out. While practicing for IPSC the bullet has been getting stuck in the barrel while I "unload and show clear".
What the heck is happening here!?!? If there a problem with my gun, is it the reloads? I'm also using primarily winchester brass.
Been reloading 9mm for a few months now for my CZ75bd. Loaded 500 rounds of Laser-Cast 124grains with 4.2grains w231. COL was 1.100. I had no problems with these and they functioned fine. Now I'm using 115 grain Meisters with 4.3grains of w231. Same COL. Now I'm having problems with the slide not going all the way back when loading a new mag or when the slide recoils after a shot. The slide locks up and it's hard to get the round out. While practicing for IPSC the bullet has been getting stuck in the barrel while I "unload and show clear".
What the heck is happening here!?!? If there a problem with my gun, is it the reloads? I'm also using primarily winchester brass.